Agriculture & Irrigation

Efficient water delivery for farms, orchards and rural schemes — from deep borehole supply to pressurised sprinkler and drip networks.

Irrigated farmland with sprinklers

The Challenge

Irrigation pumping is seasonal, often continuous during peak growing periods, and sensitive to operating cost. Diesel and electricity are among the largest variable costs on a farm, so a small efficiency difference compounds across thousands of running hours each season.

Water source varies enormously too: deep boreholes needing high head, open canals and reservoirs with fluctuating levels, or rivers carrying sand and silt that accelerate wear. Each imposes different demands on suction capability, impeller material and motor protection.

Installations are often remote, with limited technical support available locally. That favours simple construction, easy servicing and protection against dry running when a source level drops unexpectedly.

Our Solution

We select irrigation pumps against the actual system curve, not just a nominal duty point. Because sprinkler and drip networks follow a steep system curve, the pump must deliver useful pressure across a flow range rather than at one fixed condition — which changes both the model and the advisability of variable speed control.

  • Submersible borehole configurations for deep wells with limited suction margin
  • Multi-stage options where the required head exceeds single-stage capability
  • End-suction centrifugal pumps for surface water, canals and reservoir draw-off
  • Abrasion-resistant materials where sand or silt is present in the source
  • Efficiency-focused selection to reduce seasonal energy or fuel cost
  • VFD-ready motors where demand varies across the irrigation cycle
Typical service range we configure for
ParameterTypical Range
Flow rate10 – 1200 m³/h
Head15 – 200 m
Water temperature0 – 40 °C
SourceBorehole, canal, reservoir, river
Solids toleranceClean to lightly silted water
Duty cycleSeasonal continuous

Typical Duties We Cover

Deep Borehole Supply

High-head submersible configurations for wells where suction lift is impractical.

Sprinkler Irrigation

Pressure-stable supply across multi-zone networks with varying flow demand.

Drip & Micro-Irrigation

Lower-flow higher-pressure duties requiring filtration upstream of the emitters.

Flood & Furrow Supply

High-volume low-head transfer from canals or rivers with minimal lift.

Greenhouse Circulation

Continuous low-head circulation for fertigation and climate control systems.

Livestock Water Supply

Reliable year-round supply with protection against source depletion.

Recommended Products

Series most frequently specified for irrigation service.

FAQ

Should I choose a submersible borehole pump or a surface centrifugal pump?
It depends mainly on suction lift. If the water level is more than about 6–7 m below the pump, a surface installation will struggle with priming and cavitation, and a submersible borehole unit is the safer choice. For shallow sources, a surface centrifugal pump is usually cheaper to install and easier to maintain.
Is a variable speed drive worth it for irrigation?
Where your flow demand varies — multiple irrigation zones of differing size, for example — a VFD often pays back quickly. Because power varies with roughly the cube of flow, running at reduced speed rather than throttling saves substantial energy over a season.
Our river source carries sand. What should we specify?
Sand in the source shortens impeller and seal life considerably. Specify abrasion-resistant materials, expect higher maintenance intervals, and consider upstream settling or screening. Tell us the sand concentration so we can recommend metallurgy and a realistic wear-parts schedule.

Planning an Irrigation Scheme?

Tell us your source type, head requirement and network layout — we’ll recommend an efficient configuration for your season.

Request a Configuration