Chemical Processing

Where the fluid governs every design decision — corrosion-resistant pumps matched to your exact chemistry, temperature and hazard class.

The Challenge

Chemical duty rarely fails because of hydraulics. It fails because a material was selected for the wrong concentration, or a seal arrangement could not cope with the vapour pressure at the operating temperature. The consequence is not just a damaged pump — a leaking seal on a toxic line is a safety incident.

Process engineers also face pressure drop budgets, batch-to-batch fluid variation, and cleaning cycles that shift pH well outside the normal operating window.

Chemical processing plant with pump installations

Our Solution

Material selection leads the specification; everything else follows.

Material & Sealing Strategy

We begin with your fluid analysis — composition, concentration, temperature and whether the duty involves suspended solids or entrained gas. From there we match wetted materials and choose the seal arrangement appropriate to the hazard class.

  • SS316L for most inorganic chemicals and mild organics
  • Hastelloy C276 for mixed acids and chloride-bearing media
  • PTFE-lined construction where metallic options corrode
  • API 682 seal plans for toxic, flammable or crystallising fluids
Typical service parameters
ParameterTypical range
Flow rate10 – 1200 m³/h
Head10 – 150 m
Operating temperature-40°C – +180°C
Fluid pH range0 – 14 depending on material
Hazard classCorrosive / toxic / flammable

Recommended Products

FAQ

What information do you need to recommend a material?
At minimum: the fluid composition and concentration, operating temperature range, whether solids are present, and any oxidising contaminants. Chloride content and pH extremes are the two inputs most often overlooked, and both materially change the recommendation.
When is a PTFE-lined pump preferable to Hastelloy?
PTFE lining generally wins on cost for aggressive mineral acids like hydrochloric and sulphuric acid within its temperature limit. Hastelloy becomes preferable when pressures, temperatures or erosion from suspended solids exceed what a lining tolerates.
How do you handle fluids close to boiling point?
Low available NPSH is the main risk. We can specify inducers, larger suction impeller eyes, or a vertical sump configuration that submerges the impeller, and we always verify the NPSH margin during selection.

Get a Material Recommendation

Send your fluid analysis and operating conditions — we’ll return a compliant proposal with documentation.