Mining & Mineral Processing

Pumps that survive abrasive, solids-laden water — engineered around wear rate and serviceability rather than headline performance.

The Challenge

Mine water is rarely clean. Suspended solids abrade impellers and casings, pH swings accelerate corrosion, and dewatering pumps often run submerged in remote sumps where a failure means flooding and lost production. In open-pit operations the pump must also follow the water level down as excavation deepens.

The real cost driver is rarely the pump itself. It is the combination of unplanned downtime, difficult site access for repairs, and how quickly wear parts can be swapped when the pump finally does need attention.

Open-pit mining operation with dewatering equipment

Our Solution

Abrasion-tolerant hydraulics combined with motor protection for unattended submerged operation.

Heavy-Duty Submersible Dewatering

Submersible units sit in the sump and follow the falling water level, eliminating suction-lift limits entirely. Because the motor is sealed IP68 with dual mechanical seals and embedded sensors, the pumps can run unattended with automatic level control.

  • High-chrome and duplex impellers for abrasive slurry service
  • Oil-filled seal chamber with moisture probe and thermal trip
  • Float or electrode level control for unattended operation
  • Replaceable wear parts to keep repair costs predictable
Typical service parameters
ParameterTypical range
Flow rate20 – 800 m³/h
Head10 – 120 m
Solids handlingup to 100 mm
Fluid pH2 – 12 depending on material
DutyContinuous, often unattended

Recommended Products

FAQ

How do you control wear from abrasive particles?
Wear rate is roughly proportional to the cube of impeller tip speed, so reducing operating speed is often more effective than simply specifying a harder material. We combine this with high-chrome or duplex hydraulics and design the casing so wear parts can be replaced rather than scrapping the unit.
Can these pumps run dry in a fluctuating sump?
Brief run-dry is survivable, but prolonged dry running destroys seals. We recommend automatic level control so the pump stops before the sump is drawn down to the suction level.
What about acidic mine drainage (AMD)?
Low pH combined with dissolved metals accelerates corrosion. For AMD duty we typically specify stainless or duplex construction and review the chloride and metal content of the water before finalising material selection.

Planning Dewatering Equipment?

Share your flow requirements and water analysis — we’ll recommend a configuration that controls wear cost.