Knowledge Center

Technical guides, selection logic and industry notes written for engineers and buyers specifying industrial pumps.

Content note
This Knowledge Center ships with five moulded article templates. Titles, excerpts and each article body are managed through the content system — replace the sample text with your own technical material before launch.

Latest Articles

Selection guides, troubleshooting notes and maintenance practice.

Prefer to Talk to an Engineer?

Guides are useful for narrowing options, but a real selection depends on your duty point, suction conditions and fluid chemistry. Send us those details and we’ll verify the selection before you commit to a purchase.

  • Duty point and NPSH margin checked by an application engineer
  • Material recommendation based on your fluid analysis
  • Certified performance curves supplied with the quotation

Frequently Asked Questions

Short answers to the questions behind every article in this Knowledge Center.

How much flow and head do I need before selecting a pump?
Flow comes from your process demand. Head is the sum of static lift plus all friction losses in suction and discharge piping, valves and fittings at the required flow rate. Both must be known before a curve can be matched — selecting on pipe diameter alone leads to a pump operating away from its best efficiency point.
Why does NPSH matter so much in pump selection?
If available NPSH at the suction is less than the pump requires, the liquid vaporises at the impeller eye and the bubbles collapse inside the pump. That cavitation erodes the impeller, damages the seal faces and produces characteristic gravel-like noise. Checking NPSH margin before ordering prevents the most common cause of premature pump failure.
Should I choose a centrifugal or a positive displacement pump?
Centrifugal pumps suit low-viscosity liquids at moderate to high flow and lower head, and their flow varies with system pressure. Positive displacement pumps deliver near-constant flow regardless of pressure and handle high-viscosity fluids and precise dosing better. Viscosity and required flow stability usually decide it.
How often should an industrial pump be inspected?
A practical baseline is a weekly visual check of seals, leakage, noise and bearing temperature, monthly vibration and lubrication checks, and a full alignment and performance review annually. Harsh duties such as abrasive slurries or continuous high-temperature operation justify shorter intervals.
Can I run a pump below its rated flow?
Briefly, but sustained operation far below the duty point increases radial load on the impeller, raises internal recirculation and temperature, and shortens bearing and seal life. If flow varies widely, a variable speed drive or a properly sized bypass is usually better than throttling alone.

Need Help Selecting a Pump?

Ask our engineers — we’ll help you find the right solution for your specific application.

Ask Our Engineers