HVAC & Cooling Systems

Efficient circulation for chilled water, condenser water, heating loops and boiler feed — selected against real system curves rather than nominal duty points.

Building HVAC plant room pipework

The Challenge

HVAC pumping is a study in part-load operation. A system sized for the design day spends most of the year running well below that condition, which means efficiency at part load frequently matters more than efficiency at the duty point printed on the schedule.

Chilled water and condenser duties also operate close to their temperature limits, so available NPSH can be tight — particularly for pumps drawing from open cooling towers. Hot condensate extracted from a receiver is warmer still, and the margin shrinks further.

Finally, these pumps live in occupied buildings. Noise and vibration are not abstract concerns but complaints waiting to happen, and a poorly chosen pump will transmit both through the structure.

Our Solution

We specify HVAC pumps against the whole operating envelope. In practice that usually means confirming performance at several points across the load range, checking the pump stays near best efficiency where it actually spends its hours, and pairing it with variable speed control where the profile justifies it.

  • End-suction and vertical inline configurations for compact plant rooms
  • Low NPSH arrangements for cooling tower and hot condensate duty
  • Double-suction split-case designs for high-flow primary circuits
  • VFD-ready IE3 / IE4 motors for part-load efficiency
  • Low-vibration construction with appropriate base and coupling selection
  • Trim materials matched to treated water chemistry
Typical service range we configure for
ParameterTypical Range
Flow rate10 – 3000 m³/h
Head10 – 100 m
Chilled water temperature4 – 12 °C
Heating water temperatureup to 120 °C
Cooling mediumChilled water, treated water, glycol mixtures
Duty cycleContinuous with strong part-load variation

Typical Duties We Cover

Chilled Water Circulation

Primary and secondary loops serving air handling units and fan coil systems.

Condenser Water

Heat rejection to cooling towers, where suction conditions require careful checking.

Heating & Hot Water Loops

Elevated-temperature circuits with trim materials rated for the duty.

Boiler Feed

Higher-pressure feed where multi-stage construction becomes necessary.

Condensate Return

Hot condensate extraction where available NPSH is frequently the limiting factor.

District Energy

Larger distribution networks serving multiple buildings from a central plant.

Recommended Products

Series most frequently specified for HVAC service.

FAQ

Should HVAC pumps always run on variable speed drives?
Not always, though it is common on variable-flow systems. Because power varies with roughly the cube of flow, variable speed delivers large savings where demand genuinely varies. On a constant-flow primary loop the benefit is far smaller and the added complexity may not be justified.
Why does NPSH come up so often on chilled water systems?
Pumps drawing from open cooling tower basins operate near the basin waterline with fluid at close to saturation temperature, so the available margin is small. We check the suction line losses and elevation carefully rather than assume nominal head figures are sufficient.
How do you address noise complaints from plant room pumps?
Noise usually enters through structure rather than air, so we look at pump speed, alignment, base inertia and flexible connections together. Selecting a lower-speed unit often reduces noise more effectively than adding acoustic treatment afterwards.

Specifying an HVAC System?

Send your flow, head and part-load profile — we’ll recommend an efficient configuration and check the suction conditions.

Request a Configuration