Pump Solutions for Chemical Processing Plants

In chemical service the pump rarely fails because of its hydraulics. It fails because of what the fluid does to the material or the seal.

Template article
This page ships as a content mould. Replace the sample body below with your own technical material — every heading, paragraph and list item is editable through the content system.

Why Chemical Service Is Different

A pump handling water can usually be selected from a catalogue with confidence. A pump handling hydrochloric acid, caustic soda or a hot organic solvent cannot. The duty point still matters, but the dominant risk shifts to corrosion, seal failure and the consequences of leakage — which may be environmental, toxicological or explosive.

That difference explains why chemical duty takes longer to specify, and why the cheapest option is almost never the lowest cost over the life of the installation.

Material Selection

Material choice is driven by the specific fluid, its concentration, temperature and any contamination present. Stainless 316L covers a broad range of organic chemicals and mild inorganic duties. Where chlorides or strong reducing acids are present, duplex stainless, Hastelloy C276 or PTFE-lined construction becomes appropriate.

Common chemical pump materials and their typical service
MaterialTypical ServiceLimiting Factor
SS316LMild organics, many inorganic salts, dilute causticChloride pitting and stress corrosion cracking
Duplex stainlessChloride-bearing fluids, higher strength dutiesTemperature ceiling, cost and fabrication complexity
Hastelloy C276Strong oxidising and reducing acids, mixed streamsHigh material cost
PTFE-linedAggressive acids and solvents across wide pH rangeVacuum resistance, permeation and temperature limits

Sealing Strategy

Mechanical seal selection determines both emissions compliance and maintenance frequency. Single seals suit benign fluids; double or tandem cartridge seals are used where leakage cannot be tolerated, where the fluid is toxic or flammable, or where dry running risk exists.

Cartridge construction reduces installation error, which is a leading cause of premature seal failure. Where appropriate, a seal flush plan per API 682 controls temperature, pressure and contamination at the seal faces.

Standards That Govern Specification

  • ISO 5199 / ISO 2858 — dimensional and performance basis for chemical centrifugal pumps
  • API 610 / ISO 13709 — where refinery-grade ruggedness and documentation are required
  • API 682 — mechanical seal systems and flush piping plans
  • ATEX / IECEx — equipment for potentially explosive atmospheres

What We Need From You

A reliable material recommendation requires: full fluid composition including trace contaminants, concentration, operating and upset temperatures, pH, solids content and whether the duty is continuous. Suction conditions matter too, since low NPSH margin frequently interacts badly with aggressive fluids.

Need a Material Recommendation?

Send your fluid analysis and operating conditions — we’ll recommend metallurgy and a sealing arrangement, with reasoning you can review.

Request a Review