Centrifugal Pump vs Positive Displacement Pump

Two families, two very different behaviours. Understanding the distinction prevents most misapplication problems before they reach site.

Template article
This page ships as a content mould. Replace the sample body below with your own technical material — every heading, paragraph and list item is editable through the content system.

The Fundamental Difference

A centrifugal pump transfers energy to the fluid by accelerating it through a rotating impeller, converting velocity into pressure in the volute or diffuser. Flow is therefore a function of system resistance: restrict the discharge and the flow falls, and at zero flow the pump simply churns.

A positive displacement (PD) pump traps a fixed volume of fluid per revolution or stroke and forces it into the discharge line. Flow depends on speed and displacement, largely independent of discharge pressure — which is why PD pumps always require relief protection.

Head-to-Head Comparison

Centrifugal vs positive displacement characteristics
CharacteristicCentrifugalPositive Displacement
Flow vs pressureFlow varies strongly with system pressureFlow nearly constant regardless of pressure
Viscosity handlingPoor efficiency above roughly 200 cStSuited to high-viscosity fluids
Dead-head operationTolerated briefly with limitationsNever permitted — relief valve mandatory
Self-primingGenerally requires primingMost designs self-prime
PulsationSmooth outputPulsing output (dampeners often needed)
Typical useHigh flow, low-to-medium head, clean fluidsLow flow, high pressure, viscous or shear-sensitive fluids

Where Viscosity Decides the Answer

Viscosity is the most common deciding factor. As viscosity rises, friction losses inside a centrifugal pump climb steeply: head and efficiency drop while power demand grows. Beyond about 200 cSt the penalty usually becomes unacceptable, and a rotary PD pump becomes the correct choice.

Conversely, for water-like fluids at high flow rates, centrifugal designs are far simpler, cheaper to maintain and smoother running. That is why they dominate water supply, HVAC circulation and most general industrial transfer duties.

Practical Selection Guidance

  • Choose centrifugal for high flow, low head and clean or lightly contaminated fluids
  • Choose positive displacement for viscous fluids, metering accuracy, or high pressure at low flow
  • Never operate a PD pump against a closed valve without pressure relief
  • Consider shear sensitivity: some fluids degrade under the tight clearances of a PD pump
  • Compare total lifecycle cost, including energy, spare parts and maintenance intervals

When Neither Is Obvious

Slurries, abrasive suspensions and entrained-gas mixtures sit in a grey zone where standard guidance breaks down. These cases deserve engineer-level review, because the cost of getting it wrong is measured in unplanned downtime rather than purchase price.

Unsure Which Type Fits Your Duty?

Share your fluid properties and duty point — we’ll recommend the right pump family, even when the answer isn’t one we supply.

Ask an Engineer