Submersible Pumps

Fully submersible motor-pump units that operate inside the fluid — no priming, no suction limitations, built for continuous dewatering and deep well duty.

HUARUI HS submersible pump during mining dewatering operation

Overview

Because the unit sits below the water line, a submersible pump avoids the priming and suction-lift limits that constrain surface-mounted pumps. The HUARUI HS series combines a sealed IP68 motor with abrasion-resistant hydraulics for dirty water and slurry-bearing service.

  • IP68 motor with thermal and moisture protection sensors
  • High-chrome or duplex impellers for abrasive, solids-bearing water
  • Double mechanical seal in an oil-filled chamber
  • Automatic float or electrode level control available

Technical Specifications

Typical operating envelopes; final configuration depends on installation depth and fluid characteristics.

General specifications
Parameter Specification
Flow rateup to 800 m³/h
Headup to 120 m
Motor power0.75 kW – 315 kW
Discharge size50 mm – 400 mm
Max submergence depthup to 50 m
Fluid temperatureup to +40°C (higher on request)
Max solids sizeup to 100 mm depending on model
Motor protectionThermal overload, moisture probe, IP68
MaterialsCast iron, high-chrome alloy, SS304, SS316L, duplex

Applications

Typical services where this series is specified.

Mining Dewatering

Open-pit and underground water control with abrasive-tolerant hydraulics.

Explore this application →

Construction & Foundation

Excavation dewatering, cofferdams and basement drainage.

Wastewater & Sewage

Lift stations, treatment plant transfer and effluent handling.

Deep Well Supply

Borehole extraction for agriculture, industry and municipal supply.

FAQ

What protection prevents motor failure underwater?
Each unit combines an IP68 sealed motor, a dual mechanical seal in an oil-filled chamber, plus embedded thermal sensors and a moisture probe in the seal chamber. These trip the starter before overheating or water ingress damages the winding.
Can these pumps run dry?
Extended dry running should be avoided. Dry operation removes both cooling and lubrication from the seals and bearings. We recommend level-control float switches or electrodes for unattended installations.
How do I size for abrasive mine water?
Beyond flow and head, we need solids concentration, particle size and hardness. These inputs drive impeller material choice (high-chrome or duplex) and a reduced operating speed, which together control wear rate.

Request Pricing for This Series

Tell us your flow, head and water conditions — we return a matched proposal with lead time.