Pump Applications by Industry

Every industry places a different demand on a pump. Here is where our four core series are deployed — with the selection logic behind each recommendation.

Industry Solutions

Select an industry to see recommended series, operating challenges and how we address them.

How We Match Pumps to Applications

A structured selection process removes guesswork and reduces lifecycle cost.

Duty Point Analysis

We calculate required flow, static head and friction losses to establish the true operating point.

Fluid Compatibility

Chemistry, temperature, viscosity and solids content drive material and seal selection.

NPSH Verification

We verify available NPSH exceeds pump requirement to prevent cavitation damage.

Lifecycle Costing

Energy use, wear parts and maintenance intervals are weighed alongside purchase price.

Frequently Asked Questions

Common questions when matching a pump to an industrial duty.

How do I know which pump suits my industry?
Begin with the fluid and the duty conditions. Clean water duties generally use centrifugal pumps; corrosive or hazardous fluids require alloy or lined chemical pumps with appropriate sealing; flooded pit or dewatering duties favour submersible units; high-temperature or high-pressure hydrocarbon service calls for API 610 construction. Select an industry above to see the reasoning in detail.
What causes most pump failures in industrial service?
In practice the common causes are cavitation from insufficient NPSH, incorrect material selection for the fluid, dry running, misalignment and operation far from the design duty point. Most are avoidable through correct selection and routine inspection rather than by buying a heavier pump.
Can one pump serve several different duties?
Sometimes, but it is rarely economical. A pump sized for its most demanding duty will run inefficiently elsewhere and may operate far from best efficiency point, shortening seal and bearing life. Matching each duty individually usually costs less over the lifecycle.
What operating data should I send with an enquiry?
Flow rate, total head including static lift and friction losses, fluid type with temperature and chemical composition, solids content, suction arrangement or available NPSH, power supply and installation constraints. This allows a duty-matched proposal rather than an estimate.
Do you cover industries not listed here?
Yes. The eight industries shown are the most frequent, but we configure pumps for specialised process duties including pulp and paper, food and beverage, desalination and general manufacturing. Describe your conditions and we will engineer to them.

Don't See Your Industry?

We configure pumps for specialised duties not covered here. Describe your operating conditions and we’ll engineer a solution.