Power Generation

Circulating water, condensate extraction and auxiliary pump solutions built for continuous operation in thermal and renewable power plants.

Power generation plant with cooling towers

The Challenge

Power plants run pumps harder than almost any other industry. Circulating water pumps move enormous volumes continuously for years between major overhauls, and an unplanned stoppage costs far more in generation revenue than the pump itself.

Condensate duties sit at the other extreme. Extracting water from a condenser under vacuum gives very limited NPSH margin, so cavitation risk is structural rather than incidental. Boiler feed taken from a hot deaerator faces the same problem for the same reason.

Seawater cooling introduces corrosion; ash and flue-gas desulphurisation slurries introduce abrasion. Many plants deal with all of these at once, which is why auxiliary pump selection is rarely a single decision.

Our Solution

We approach each auxiliary duty separately, because the constraints genuinely differ. High-volume low-head circulating water favours large split-case or axial-flow machines running near best efficiency point. Vacuum-side condensate duty demands generous NPSH margin, often achieved with a low-specific-speed first stage or a can-type arrangement.

  • Axially split-case designs for high-flow circulating and cooling water service
  • Low NPSH configurations for condensate extraction and hot boiler feed duties
  • Multi-stage barrel designs where feed pressures exceed single-stage capability
  • Seawater-compatible construction — duplex, super duplex or bronze fitted where applicable
  • Abrasion-resistant materials for ash slurry and FGD recirculation
  • Full documentation packages including performance curves and material certification
Typical service range we configure for
ParameterTypical Range
Flow rate50 – 6000 m³/h
Head10 – 300 m
Operating temperatureAmbient to 180 °C
Cooling mediumFresh water, brackish water, seawater
Available NPSHOften very limited on vacuum duties
Duty cycleContinuous base load

Typical Duties We Cover

Circulating Cooling Water

High-flow low-head duty supplying condensers and cooling towers on continuous base load.

Condensate Extraction

Vacuum-side extraction with minimal available NPSH and elevated water temperature.

Boiler Feed

High-pressure multi-stage feed taken from deaerator or hot well conditions.

Seawater Cooling

Coastal once-through cooling where chloride corrosion governs material choice.

FGD & Scrubber Duty

Abrasive limestone slurry recirculation requiring wear-resistant construction.

Ash Handling

High-abrasion slurry transfer where wear parts dominate maintenance planning.

Recommended Products

Series most frequently specified for power plant auxiliary duty.

FAQ

Why does NPSH matter so much on condensate duty?
Because the water is drawn from a condenser under vacuum at a temperature close to saturation. Available NPSH is inherently low, so both installation design and pump specific speed must be considered together. We generally recommend confirming the margin with a full suction-side calculation before finalising a model.
Which materials suit seawater cooling?
Chloride content and temperature determine the answer, but duplex and super duplex stainless steels, bronze-fitted construction and protective coatings are all common. We select against your actual chloride level and seasonal temperature range rather than applying a general rule.
Do you supply the documentation typically required by EPC contractors?
Yes. Performance curves, material certifications, hydrostatic test records and dimensional drawings can all be supplied with the order. Lead times for extended documentation packages should be discussed at enquiry stage.

Specifying Power Plant Auxiliaries?

Send your duty points, suction conditions and cooling medium analysis — we’ll propose a configuration with documented margins.

Request a Configuration