Wastewater & Sewage Treatment

Clog-resistant, abrasion-tolerant pump solutions for municipal sewage, industrial effluent and sludge-handling duties.

Wastewater treatment plant basins

The Challenge

Wastewater is the least forgiving common duty a pump faces. The fluid carries rags, grit, wet wipes and fibrous solids that wrap around impellers; it varies in consistency hour by hour; and it is frequently corrosive through hydrogen sulphide or industrial contamination.

A blockage does not merely reduce output — it stops flow entirely, which in a collection network means overflow and an environmental incident. Reliability therefore depends less on hydraulic efficiency than on passage size, impeller geometry and protection against dry running.

Sludge adds its own problem. Thickened sludge behaves as a non-Newtonian fluid, so standard performance curves no longer describe behaviour well and power consumption rises sharply with solids concentration.

Our Solution

We configure each wastewater duty around the solids it actually carries. Submersible sewage pumps with non-clog impellers and generous free passage sit in the wet well where they prime reliably and need no suction pipework. For dry-installed duties we use end-suction centrifugal pumps with channel or vortex impellers chosen to match particle size.

  • Non-clog and vortex impeller options matched to measured solids size
  • Large free passage to reduce rag wrapping and blockage frequency
  • Abrasion-resistant wear parts, with high-chrome or duplex where grit loads are high
  • Mechanical seal faces specified for abrasive service, with oil-filled seal chambers
  • Motor protection against moisture ingress, overheating and dry running
  • Level control by float switch or electrode for unattended wet wells
Typical service range we configure for
ParameterTypical Range
Flow rate20 – 1500 m³/h
Head10 – 80 m
Fluid temperature0 – 60 °C
Solids handlingUp to 100 mm free passage (configuration dependent)
pH range4 – 10
Duty cycleContinuous with intermittent peak flows

Typical Duties We Cover

Raw Sewage Lift Stations

Submersible pumps moving unscreened sewage from collection wells to the treatment headworks.

Return Activated Sludge

Continuous low-head recirculation between secondary clarifiers and aeration basins.

Sludge Transfer & Thickening

Higher-viscosity duties where non-Newtonian behaviour dictates power margins.

Industrial Effluent

Pre-treated discharge where chemical composition may also require alloy construction.

Effluent Discharge

Treated water release to receiving waters or onward reuse systems.

Screening & Grit Handling

Grit-laden flows where abrasion resistance defines service intervals.

Recommended Products

Series most frequently specified for wastewater service.

FAQ

How do I choose between a non-clog and a vortex impeller?
Non-clog (channel) impellers deliver higher efficiency with good solids passage and suit most raw sewage duties. Vortex impellers give excellent passage with lower efficiency, because the impeller sits out of the flow path — they suit very stringy or abrasive flows. Tell us the solids characteristics and we’ll recommend accordingly.
What causes repeated blockages in a lift station?
Repeated blockages usually indicate free passage too small for the solids present, or an operating point too far left on the curve where velocity through the impeller drops. Both are selection issues rather than pump defects — worth reviewing before replacing equipment.
Can the same pump handle both sewage and sludge?
Sometimes, though not optimally. Sludge has substantially higher viscosity, which raises power demand and lowers head. We generally size the motor for the sludge duty and verify performance at that condition rather than assuming the sewage curve still applies.

Planning a Wastewater Project?

Send your flow figures, solids characteristics and wet well layout — we’ll configure a clog-resistant selection with appropriate protection.

Request a Configuration